Kemp R Series Manuel d'utilisateur télécharger pdf (Page 6)

LoadMaster for the Dell R-Series

LoadMaster for UCS Installation

Installation Guide

2 Connect the Dell R-Series

Here is some information about the Dell R-Series ports:

 Eth0 to eth5 = 1GB copper Network Interface Cards (NICs)

 Eth6 and eth7 = 10GB SFP+ ports

To connect the Dell R-Series, follow the steps below:

1. Install the Dell R-Series into a 19 inch rack or another safe location.

2. Connect Ethernet cables to the ports on the Dell R-Series. Please use the worksheet

included in the pack to determine which ports to connect. For single-arm setups, the

switch only needs to be connected to port 0.

3. Connect the monitor and keyboard to the Dell R-Series (or just a serial cable).

4. Connect the power cable to the Dell R-Series.

5. Turn on power to the unit.

The installation then completes as shown in Figure 2-1.

Figure 2-1: Installation Complete

1 2 3 4 5 6 7 8 9 10 11 ... 24 25

Pas de commentaire

Kemp R Series Manuel d'utilisateur Page 6